Lambo XL

Lambo XL Stainless Steel Variable Voltage kit comes with one(1) Tube, two(2) 18650 Batteries, and one(1) Trustfire charger. The Lambo XL kit does not come with an atomizer or drip tip.

Lambo Features:

•  Stainless steel body
•  1- power button
•  1- voltage up button
•  1- voltage down button
•  1- activation button
•  1- LCD screen, which shows the current voltage the device is set on.
•  1- 510 threaded connection with outer Ego style cone threading. Center contact post is spring loaded.
•  1- vented removable end cap w/ spring for battery tension
•  Uses 1- 18650 LiMN battery

Tech Specs:

•  Selectable voltage from 3v to 6v in 0.1v increments
•  Power on/Off Button - hold the button down for 5 seconds to turn the device on, hold the button again for 5 seconds to turn the device off.
•  "+" Button: On press, increases voltage by .1 increments between 3volt and 6 volt. When you reach 6 volts, the user starts back at 3 volts
•  "-" Button: On press, decreases voltage by .1 increments between 3volt and 6 volt. When you reach 3 volts, the user starts back at 6 volts
•  "+" and "–" Button: Press and hold both buttons for five second to disable the "+" and "–" button, locking the device on the voltage it is currently set at.
•  Regulated output which keeps the voltage the same with each puff - regardless of the remaining battery power. As the battery drains, the device will keep the voltage consistent.
•  If the activation button is held down for 10 seconds or longer, the Lambo will shut itself off until the button is released. To prevent overheating the atomizer and the device.
•  Short Circuit/Atomizer Protection. The Lambo can recognize an atomizer with too low of a resistance for the current voltage setting and will drop the voltage to 3.7v to protect both the battery and atomizer. If the atomizer is too low or shorted out it will shut off power to the device to protect the Lambo from being damaged.
•  Reverse Battery Protection – Protects the device in case you put the battery in the device backwards
•  Battery Monitoring/Over-Discharge Protection – The device will monitor the battery voltage and automatically turn off when the battery is discharged, preventing damage to the battery by overly depleting it.
•  Battery Voltage Meter. The Lambo has a voltage meter built in, simply press the red power button 7 times and it will display the voltage of the battery for a few seconds. This way you can monitor the power left in the battery before it needs to be recharged. 18650 batteries provide 4.2v at peak charge and over the life of the battery that voltage will decrease to about 3.3v level before needing to be recharged. This will help you monitor the life cycle of the battery. The LCD screen will flash when the battery needs to be recharged, and will stop powering the device.
•  Amperage Limiting to 2.5 amps – The device should monitor and shut itself off if it detects any excessive over-current conditions.
•  Vent hole on the bottom of the device for added safety

Suggested Accessories:

306 Atomizer Standard

Aluminum Cannon Drip Tip

Bridgeless 510 Atomizer Standard

510 Ceramic Ming Drip Tip